• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Ultraflex 12oz on r1000

Neila Printing

New Member
Having issues running 12oz dss on the r1000, have tried a variety of settings and have calls in to both ultraflex and HP and they're just pointing at each other, no matter the heat settings the material creates. Anyone had luck with it?
 

Attachments

  • PXL_20231219_215202866.jpg
    PXL_20231219_215202866.jpg
    921.7 KB · Views: 152
  • PXL_20231219_213648535.jpg
    PXL_20231219_213648535.jpg
    788.8 KB · Views: 102

johnnysigns

New Member
What's the temperature in your shop and/or of the media? Only time I've had issues like this is throwing on material right after it was delivered and cold into the machine.
 

balstestrat

Problem Solver
Reduce curing vacuum as much as possible. It will relax more and not create those tunnels.
Also if curing pressure seems high, take it down a notch.
 

Brian Tickenoff

New Member
If you pull out some media and push it through the press to the other side, do you see those wrinkles? Not hitting “load”, just feed it though by hand and give it some manual tension from the back to straighten it out.
If you see those wrinkles, it’s the media.
I’ve had similar issues on both our r2000 and 3600. It was the media. Something about poor converting from the manufacturer.
 
Top