• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by amgraph

  1.

    How long does it take you to letter a truck?

    How do you use Stabilo for alignment? The majority of my work is Fleet and I've seen Stabilo marks on some trucks i'm rebranding. It always seemes like it's double the work. I just tape the graphics roughly in place than measure one corner than the other with a tape. A quick double check of the...

  2. what do you think of the mutoh toucan LT

    Hi Ben, Once we got it going as poslive said the thing would just run. Had to replace the pumps and when I left the feed reel sounded iffy but aside from that we really had no problems. Still had the original heads after 6 years and even they were acceptable. We would load a 100 yard roll of...

  3. what do you think of the mutoh toucan LT

    Had one at our last shop. Once it was properly set up I loved it. We could print an entire roll of material pretty much unattended. It also seemed to print better (higher quality) than the vJ. Im guessing the two additional Lc and Lm gave it a better/higher density...

  4. Mutoh 1204 Printing on Engineer Grade Prismatic

    One offs and short runs are typically printed on a specific UV printer. The new DOT standard reflective made by 3M is a screen or UV printable material only. We just print on clear/contour cut and mount. Not technically correct but it works.... Andy
  5.

    I would appreciate

    Have you actually created a cut line under either effects> contour cut or converted a line under arrange contour cut make? You can also do >select by attributes and look under stroke. There should be a stroke named Contour Cut.
  6.

    I would appreciate

    Are there registration marks shown in the preview for production manager?

  7. Production Manager

    Also, as an aside, This must be a bug. I have a 250GB HD (not a partition) that is basically empty and I get the same message on occasion. This drive is dedicated as a scratch disk and I don't keep but a couple of Ripped files there at any time. Andy

  8. Production Manager

    Under Production Manager > Edit >Preferences Good Luck, Andy

  9. Is this possible in Flexi ?

    I know under Cutter driver options in PM there is a "before job" tab and down at the bottom you can see the codes that are sent to the cutter. I seem to remember that you can add codes somehow to that line. I believe that you just need the correct code.. Andy

  10. seek failed - Flexi

    We are having the same exact problem in 8.6. When we load up 8.2 - no problem. The new flexi has me pulling my hair out.... Andy
See more
Top