• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by Andre@Beith

  1. Need Help KALA MISTRAL _ ARKANE _ CODE L08

    Hi Also getting this code L08 on Kala Arkane. It has 2 pinch roller motors on either side. The one motor does not come on. Have replaced the motor and happens again. Has anybody experienced the same as i have also send Kala a mail but no reply. Have to go through the agent but agent also...

  2. Choosing a RIP

    Have a look at Printfactory. You can run all your printers and cutters on one rip.

  3. Need Help Fotoba XLD 170 service manual

    Hi Carl Yes they do last forever i have removed and cleaned the sensors. Will contact Fotoba thanks

  4. Need Help Fotoba XLD 170 service manual

    Hi Does anyone know were to get the service manual for the Fotoba XLD 170 cutter need to do adjustments on the mark sensors as its not picking up the mark.

  5. Need Help Epson Dx5 Magenta firing issue

    Hi Ajith Sounds like your magenta ink line. Could be the tubing as you print its getting air. had it before when you do your clean and nozzle print all is fine but when you start printing colour dissapears. had a hairline crack in the ink tube

  6. Zund Cutter G3 L-3200 error 28F03

    Hi need some help on a Zund G3 error 28F03 zero mark of t-axis not found on the universal module Have replaced the drive belt and zero mark sensor. Is there a specific way to install the belt to see the zero mark?
See more
Top