Recent content by B-Man

I didn't realise it was all their products that had this issue. Spent ages looking for the drivers.

where are the new drivers? I cant find the new drivers... https://downloadcenter.rolanddg.com/GX-24

Have you paused updates and successfully uninstalled KB5039211?

ok so from help from roland I couldn't see KB5039211 until after uninstalling the other updates but if you don't pause your updates it reinstalled it the next boot... I don't know what to do in 4 weeks when it wants to install it again... Thank you for reaching out to Roland DG Support...

im having the same issue but i cant uninstall the update.... it shows its installed in the update history but when i try the uninstall methods it says it isnt installed.... im thinking it might have been a part of the windows 10 servicing stack 10.0.19041.4467 but apparently you cant uninstall...

went to set it up and I don't have the option listed... https://www.rolanddga.com/support/products/cutting/camm-1-gx-24-24-vinyl-cutter/article?pm=GX-24&articleId=cutting-corners-cleanly-gs-24-enduser

thanks will give it a shot next time I do something small like i have.... from first google it looked like there wasn't an overcut feature on the gx24 but have now seen some documentation that there is an option of on or off. Cheers,

I have been having some issues with letters and numbers not fully cutting... for some reason I found out my offset was at 0.100mm. Where 0.250mm is standard for the 45° blade. I'm doing some very fine small numbers for myself to label bottles so used the 60° blade and set the offset to 0.400mm...

that only comes in 1234mm rolls rather than ~610

Just have an account with orafol more than prefer their products. I would have thought most should stick to non metallic surfaces but they all say even metallic surfaces. Will check out Nikkalite Thanks all.

looking for a white reflective vinyl for numbers to stick to some plastic squares can anyone recommend a reasonable priced vinyl? I use oracal 551 for normal stuff. I'm thinking Oralite 5500 as it seems to be the only oralite that doesn't say "The material is strictly intended for adhesion onto...

yes its very basic. I find it good to do the simple tasks I do. No need to overcomplicate it. I have corel draw but don't really know how to use it to its potential.

I need to make a heap of numbers starting at 1 and going up to 200 Is there any way I can do this without having to manually type each number? I use cutstudio.

South Australia not to far from the Vic border

I'm also after an application tape dispenser. I have built a basic one on a piece of broom handle that's elevated off the bench that I just pull off the roll and stick a few inches in front of the decal and then squeegee it on. Looking for one that will unroll and apply in one motion. I seem...