• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by ColbertSignWorks

  1. Graphtec Solution Needed

    Manual helped a lot. Thanks Case. On my way to getting this Graphtec to do what I've seem the do. Thanks everyone for all the help.
  2. Member Album by ColbertSignWorks

    Member Album by ColbertSignWorks

  3. Junk Monkey

    Junk Monkey

    5 Layer Art
    • ColbertSignWorks
    • Media item
    • Comments: 0
    • Album: Member Album by ColbertSignWorks

  4. Graphtec Solution Needed

    It has just enough holding it to pull the cut image while weeding. You can hold down with finger while weeding and tear the uncut portion. This does not occur on every letter all the time. Some letters cut perfect and some don't.

  5. Graphtec Solution Needed

    Just tried your test. 2" Caps Arial Bold.1" square. It cut everything. The text had little peices connecting the letter to the sheet vinyl. The letters are cut at a poor quality. Some lines that should be straight are crooked and the arcs on other letters are not smooth. One edge of square not...

  6. Graphtec Solution Needed

    I have tried running the offset up and down, no help. I checked the blade holder and blade, all looks good. Also it is having trouble cutting straight lines. Example... Arial Blk font with a capitol A all lines should be straight with sharp corners. From one corner to the next cuts are not...

  7. Graphtec Solution Needed

    I have a Graphtec FC5100-75 that does not completely cut. The simplest way to describe the problem is if it cuts a circle the starting point and the stopping point are not the same location. It leaves a little tab connecting the circle with the vinyl you would weed. Have changed all sorts of...
See more
Top