Recent content by colorwheel

Cutting from Flexi not versa works

Thanks i will give it a try.

When i go to cut a contour on a circle it goes all the way around but about 1/2" or when cutting around square or rectangle cuts all sides but one.

Will give him a call. Thanks,

Looking for someone to engrave some electrical panel id tags, around 125 of them. We are located in Ga.

https://www.manualslib.com › Brands › Roland Manuals › Printer Here are service manuals on the net.

About had it with this machine. As you can see by the photos red is where it is not suppose to be. Any suggestions. Have tried Bi-directional adjustments, cleaned and soaked, manual cleaning, replaced dampers, wipers,etc. This just started after having to replace the encoder strip and having to...

That was the problem thanks

yes Flexi 10 have always used it.

All cables are in place. also ran the set and calibration in service mode with no problems. It will print the reg. marks without being striped.

Changed out encoder strip of my roland sp 540 had to go into service mode and do several things. Started to print some rectangles to check printing. Now it prints about a 1/2" then leaves 1/4" of white when print 1/2" again. It's like printing stripes.

Had already tried that and it still comes up trying to clean.

When i try to run the limit position, it keeps coming up saying cleaning no matter what. Just time the machine is turned off, it comes back on with cleaning.

Thanks i will give that a try and let you know what happens.

turn on the machines goes into cleaning mode for about 3 seconds then i get a 0101 code