I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Follow Up
Thanks for all the suggestions every one
I spoke to Accugraphics today
I have to send it back to them to find out what is going on
Guess I wont be learning to cut any vinyl for about two weeks or so.
Maybe I can get this book read " Layout " etc.. by Mike Stevens
Found one at...
Thanks Sticky Signs
I overlay several base and candy colors to achieve the Realistic Fire Look
Then it all gets top coat euro clearcoat
Looks really good on cycles , trucks, cars, etc...
Later
Cuz
No doubt Your correct
I like the best tools
They told me at accugraphics that this was a good machine
Sold me on saying it has a MICRO STEPPER MOTOR which is suppose to be better than the cheaper ones with just stepper motor
IT is Probably a fluke and I am quite sure they will help me out
Im...
Yep , a better website for airbrushing and some knowledge of Why this FOISON 24 inch cutter brand new dosent work
I had this running a few months ago. put the pen in it to do some test runs it worked perfect.
Got busy and never got back to it till this week. Got some reading material...
People told me I should have purchased a graphtec or Roland
Didnt have the cash so I went with this Piece of _______
Probably one more mistake
We shall see
I didnt get a Foison Manual with this I got their Klik N kut manual
Not sure why but anyway
I plugged it in direct to wall , No change
Im not sure where the fuse is located and the top lid does lift up and I see a cable flat and wide computer cable looks like it goes into the menu dept...
I have a power supply bar
have to use it to get power to it
It has power because the fan is running when I turn it on
Could it be something to do with program ?
wouldnt the menu screen come on even if it wasnt hooked up to my computer ?
although it is still plugged in to the computer
I purchased a foison 24 inch cutter from accugraphics in Apopka Florida
Recommended by a person on this Forum
Company seems like a good company
I guss I will try tomorrow to reach them
Its just that this dosent make any sense
Run it about 10 or 15 minutes a few months ago
turned it off
Never...
HELP from anyone
Hi all
Im kind of new here
A guy on here told me where to buy a Cutter in Florida
Can I get some help ?
A few months ago I got a 24 inch cutter brand new from a company in Florida
I got it set up and got as far as using the pen do some test runs on paper
I turned it...
Hi all
I purchased a 24 inch cutter several months ago. I was so busy with other work etc... I am just geting a chance to come back to learning how to operate it.
I have a problem :
A few months back , I set the machine up, got as far as using the pen to do test on paper to start learning the...
Thanks everyone
I really apprecitate this
I bought a 24 inch cutter from a company in Florida
It came with the equiv. of Sign lab
Im hoping to get it cutting in a few days
I will look over the info , you all have provided and I hope to pick up some of the books mentioned
Thanks again
Cuz
vehicle lettering
Oh yeah
My airbrush site has a section that says we do vinyl
This is because , I had a guy that was cutting vinyl for me and I would apply it. So , as far as putting vinyl on , I have done that a few times
making tape hinges, cutting out the letters, using a squeegee...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.