Recent content by Dacsi

This is the lamp position chart I've been using from the beginning. I was told on the training to only change the lamps when I print white+colour layers, so that's what I've been doing. Have I been doing incorrectly?

Thank you. Yes, that is on 100% as well. Never changed it to be honest. I've only messed around with the UV mode settings at the beginning when we got the machine(we had problems with ink curing) and I've been using 12 since then. After reading many things on this forum I was thinking I might...

The lamp is on correct position at 0,0 unfortunately. Yes, I do clean the glass in every couple of weeks, so that's also not the problem. This is probably a very stupid question but how can I check the lamp luminosity?

Yes, I always move the UV heads when I print white and colour(this is the only time I need to change them after reading the manual), otherwise they stay at 0,0. When I print colour layer only they should be in 0,0 and when I move the lamps the stickiness is even worse, unfortunately.

Hi guys, We're starting a new project and we had a complaint about the prints being sticky/tacky(on acrylic), so I've been researching the problem. We print wooden signs with colour layer only on white lacquered MDF and after taking them off of the printer they really feel a bit sticky(same as...

Thanks, NathanR for the attachment, it seems pretty cool. We will check this as we also noticed a little offset that can cause problems. Zendavor Signs, I'm totally new to the machine, so I'm trying to figure out the settings. Unfortunately, without the primer, the TPU didn't work before and...

Thanks very much for these guys! Now I know that I didn't miss anything (or the information is really hiding on the web) and we just need to test test test. Hopefully, the new settings are going to be good and we won't have any problem with the prints coming off of the TPU. With MDF I also...

Hey guys, New JFX-200-2513 owner here. (LUS-120 inks CMYK CPWW) We recently had some complaints about the prints coming off and bubbling up, so I’ve changed a couple of things in the settings. The material is TPU and I first started printing with these settings: 30 % primer, 100%/100% white...