I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Yeah what's weird is the printer is stuck in a loop before even running the heater/curing module. I understand if the voltage isn't correct at the printheads maybe that's why it's failing, but the load during the printhead installation protocol is not very high, certainly nowhere near printing...
i've visually inspected the flex cables, they appear to be fine and in proper position. but i really have no idea what might be wrong.
it was printing only c/lc and m/lc. after trying to run several cleanings, it eventually triggered the "reseat printhead" and i have not been able to get past...
is there any chance running the l26500 off the generator is causing the printhead reseating loop in my other post? pretty sure it's just dead printheads/bad contacts as the printer sat for a while, but i've been trying without much luck to resolve it. may just have to bite the bullet and get a...
So long story short I have an HP l26500, called electrician out, it was going to cost a lot of money to install a new panel as we didn't have enough space at the house for two 240v's.
i got the printer used very cheap and decided that mad maxing a solution be would better suited. thus, enter a...
what would be the best way to access them? so far i've been using hp's recommended technique of beginning the printhead swap, then powering down to keep access to the carriage. could i get to the board from there or would i need to dig deeper into the machine?
I replaced #4 with a new one, but the error continues. Sometimes it jumps from #4 to #3. I try swapping them, i've tried every combination of the now three y/k printheads i have and it always fails.
I guess I can ebay another printhead and switch it, but i feel like i'm just wasting money if...
So i've got an hp l26500 that is stuck in a "replace printhead" loop. It says printhead 4 is faulty; you replace it, it fails to finish the replacement, sends the carriage back to the middle, prompts you to swap the printhead again.
i've cleaned the printheads manually by placing them on a wet...
So I have this issue more frequently than I would like to admit. Using an old Jetmounter, we've been applying Drytac Multitac to 4' x 8' sheets of gatorboard for years. The rollers might be a little worn in certain areas, but the boards always roll straight as can be with a proper set-up. We'll...
I don't believe the 330 has an onboard spectro, so no I don't believe I'm using it. Sorry for the confusion on the terms. Here is my process:
>Tap on "Substrate Library"
>Tap on media category (in this case "PET Film")
>Tap on "New PET Film" at top of list
>Select which Generic Preset I want to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.