Recent content by Eirikprint

Set a new origin, as in Y origin? Just curious because its the only sensor I can think of that may be affected when we help move the plastic tray into position during start-up. Maybe the ink has built up in the grooves/slits, and the motor can feel that there is too much resistance when it's...

Will keep the e-stop in mind for next time, thank you! We checked the encoder strip, and cleaned it, and we can't see anything wrong with it. It is still tight and appears fine to the eye, and now its clean too. As shown in the last video, for some reason the printer starts fine if we help the...

Update on our situation. We talked with a technician who told us to clean the Encoder Strip - if this wasn't the problem, then it would probably be the encoder sensor. We tried cleaning but to no avail. Every startup results in a "Error 50 A - y origin" error. We noticed however that it sounds...

What is the Y-origin sensor part name for the UJF 7151 and where exactly is it located? Does anyone here know?

We did an emergency stop right after the video stopped - because we don't want to cause any harm to the printheads or carriage. Edit: I just updated the main post instead of writing more responses. Will continue updating the more we learn.

Hello, our UJF 7151 Plus II started showing "Error 404 y-origin" yesterday, and today it showed "Error 50a y-origin". After I restarted the machine today, the error was gone - and I did the following test: 1. Execute and confirm [#TEST]->[SENSOR TEST] - >[Y-ORG].(Confirm that the ON/OFF display...

Late update for any poor soul who has this problem later: Turns out it was the XZ table PCB. It was not apparent at all that this was the faulty component, everything was lighting up as it should - and we even tried swapping out the tiny fuses. Around $1600 dollars fixed this problem(new PCB)...

Thanks alot for the reply! I will look into this tomorrow. We haven't had any problems with the table seizing up or moving erratically as far as I know, but it's worth to check it out either way. I've been thinking about the error message we are getting, and the most logical conclusion I can...

Thanks for the tip, I will check it! Whenever the ballscrew was misaligned on the 6042, was there any signs before it seized? I've noticed that our table moving up and down (calibrating) on start up, has gotten progressively louder over the last year.

Hello, wondering if anybody could help me out here. Our UJF 7151 Plus is currently unusable because of the error message in the title. I've spoken to mimaki support, and they've given me the following instructions (which are not in our manual): ” SYSTEM HALT(*) 132: PCB TABLE No XZ table PCB...