Recent content by Ex3cutiv3

To close out the "Re-Seat Printhead error HP335" it turns out it was the trailing data cable as the rubber jacket had begun to disintegrate no doubt causing more flex and eventual parting of the wires or possibly shorting across to the shielding. In any case a silicone jacket would be a better...

That would have been good to know before I started, lol. Everyone else take note! The replacement FI tower kit includes the bottom piece of the tower which has the nipple to connect to the supply tube, best not to disturb that connection, and instead disassemble the rubber ring and top section...

Well, so far, to continue the saga, we have now changed out the PCA, the printhead ribbon cables (set), the FI towers (for the OP Phead only), not recommended due to brittleness of the connectors and hardness of the tubing between connectors. (broke the splitting connector that supplies ink to...

We have tried 3 new PHs but holding onto one untried until the towers are replaced. And the pca before that. Just in case. Thanks! Also expecting to receive tower installation instructions as I also understand it’s a bit tricky.

Thank-you ToTo! PCA and towers ordered. Here’s hoping, because if that doesn’t work I hear there are other printers on the market with fewer and resolvable issues, lol. Cheers!

Thanks ToTo, not really sure there is a connection between "Re-seat OP Printhead error HP335" and the possible leak. I just changed the ribbon cables for the printheads but no change to the message/error.

How did that work?

Not as helpful as one might think. Connected mechanically, by ink tube or ribbon cable? What does Fi stand for as well please? Cheers!

Thank-you! What's the Fi tower?

Just hoping there has been a solution found to this error that I might find useful. Please. Visible indication is only that there appears to have been a leak of OP at some point that may still be going on. Otherwise until I disassemble the carriage nothing else is evident. It appears changing...