Recent content by eyesx

OK, I see it now. I was looking down from the top and didn't see the side where the screws are. I really appreciate your help. You saved my life.

This is the best I could get. Point and shot camara is old and not reliable. Mind sounds different than what you mention. I don't see any screws to remove mine is at the top on the motor.

The motor is: BODINE ELE CO SER# P0449B0031 TYPE: 33A5BEPM I need to get the camera from my boss, and he is gone right now.

This is the first time I've done this hope it's not to big.

I found the spindle isn't turning. The motor that has like 6 in screws and remove the top is missing a brush, it only has one now so I'm guessing that will prevent the spindle from turning? I looked in my manual and can't find any info of how to replace this or what part to order. Information...

Anybody with experience with this setup please help. My belt broke and I replaced it. But when I removed the motor a small item like a brush for electric motor has fell out. I had no way to reinstall it so I thought I would try it and see if it works. The motor turns on, but it doesn't cut all...

Thank you I got it working.

Proxy. I use this setup for 6 years and this never happened before.

I engraved yesterday everything went fine. Today I try and the head won't go to the plastic. It goes thru the motion above the stock about 2 in but won't engrave. I shut it down and re booted and still same problem. Can anyone please explain this?

I am having a time trying to earn this machine. When I send it to the engrave icon the controller says OUT OF BOUNDS-Z 0.0100 I try to jog it back but it doesn't move. Now I'm getting y is out of bounds and again I jog it with no results. I try send it home or go to limits and it just refuses...