Recent content by EZ Ink

Ok, Broke down the machine, check fuses and main board circurity was good. Check panel box and maintence station, ran mutiply cleaning and nozzels checks. No issues Inspected lines. Ink cartridges had fresh ink coming from port, wiper had black ink, and all lines had ink, but no printing...

also, I inadvertently enter the ink initialization twice, any effect. Also when I was in maintenance menu counter reset, anything in their O should recheck, could have inadvertently enter something in error. Thanks

It appears will have to the pull control panel off and see what is going on in the maintenance station.. Anything I should be looking for?

check the flapper on the maintenace station, no ink after doing nozzle check. Where is that fuse located? I replaced the maintentance station and print head about three years ago. Everything work well last week. The recieved the LifeTime Pump error message today.

Did an ink initization, nozzle check, and cleaning. Ink is in the line. Suggestions.

Yes. It appears to work. Did a cleaning and nozzle check, and printed small box. Appears not printing at all.

Have a Mutoh1324 VJ.

Went through the above steps, when I entered Yes on the Maintenance menu for Lifetime pump and selected enter yes, no initialization occurred. The counter reset back to no. Attempted it again, nothing happened. Am I missing a step? Thanks.

Received the above error message, I drained my ink tank, how do I reset the counter. Hoping that is will remove the error code. Thanks.

Thanks for all your inputs.

Will continue to printing on the vinyl and then apply it. Was hoping to cut out a step. Yes, I have replaced print head, not somethijng, I would look forward to do again. Thanks for the input.

Recently purchase a roll of 30 mm magnet material for car signs fromm JDS, supplier Magun Magnetics. I saw on the description that I might be able to print on it, so I called Magun Magnetics, The tech informed me that I should be able to use my Mutoch VJ 1324 Wideformt printer, but the...

Thanks Joe. Have you tried or could tell me about the Printable Digi Matte White Printable Magnetic Roll, JDS is selling. I have a Mutoh 1324 Valuejet and I order a small roll to see it works. The also come in different thickness, 30 mm 20 mm and 10mm. Thanks Glenn

Is it possible to cut using the above cutter to cut car magnets? I belived the thickness is 30 mil. If not what thickness mil could be cut? Thanks.

Figure it out through trial error. It would be nice if something worked right the first time. Thanks.