Recent content by Forty One

Don't worry. I sorted it out. in your printer, you need to rename it physically under the Machine Settings menu. Default in this case is JV33-01 A quick change to JV33-02 was all it took.

Can anyone assist here? I'm running rasterlink 6 and currently have 1 x jv33-130 and 1 x UJF attached. UJF via Ethernet and JV33 via USB. I've recently purchased 1 JV33-160, and I'm having issues conneting it to RL. Mainly, it wont register a new printer. to simplify this process, and...

so, a re-circ pump system? would love to see a little video of it in action if possible.

windows 10? Have you tried removing it completely and reinstalling it? Generally when this happens a file has been courrupted etc. If a reinstall does nothing, go into System Backup and restore and see if you can restore your machine to an earlier point. Hopefully you have a point within that...

Thanks. Since I have not got a full size flatbed, I think I'll stick to manually applying it by hand

Side note, Is anyone running a primer and LH-100 inks on this? From what I can see, only LUS-120 primer is available for this, but.... is it possible to say remover the 'clear' from my config and replace it with the primer?

Don't loose faith Smoke_Jaguar . You've got the most info yet on this machine! I need a point of reference! :)

Hey Smoke_Jaguar , if and when I need to swap out the head, is it as simple as disconnecting and swapping out? Or do I need to prime the head, adjust the drop pos, slants etc?

I'll piggy back the tech when he come in to do it as I kinda know... But always helps to get a bit more hands on info. Eg, there's the adjustment via the LCD and then there's the manual adjustment on the hardware

I've succumbed to the possibility I may need a new cyan head for the printer. BUT I'm not 100% convinced yet. I've had the tech company me over and balance out the table and adjust the z axis. Also tweaked the head level and lamp etc. So I'm told the machine is level. We did some drop pos tests...

I've found that in the first gen of the 7151 it uses a lot of parts from the 3042 HG & FX models. I say a lot, but so far anything to do with the coolant system really

Keep his number. Apparently here in Australia the mimaki techs who know these machines are rarer than hens teeth. I'm having misting/overspray issues when building up braille still. I've been told various reasons and all are not making any sense. It really pissed me off that the tech told the...

+1 for the guiloutine. It gives a much nicer edge and doesnt require any finishing

Thanks. I really appreciate the help.

Stupid question but... do you adjust it with media on the table (eg 20mm acrylic), or just calibrate from the table itself?