Recent content by gpslitt

First of all, thanks everybody for helping me out. At last after a month of research and tries, I have found a solution. In Illustrator I just change the corners size from 0 to 0.005, which is not very visible with the naked eye, but CM5 don't consider the angle to be sharp anymore and...

Yes I watched it happened and stop in between. So basically you are right, as the print is not exactly straight..it assumed the edges of my print as mark..but it doesn't even look like a mark or same color. Yes it goes 4-5" both directions just to get something, which is pretty strange. It's...

There must be some setting to stop cutting if it doesn't detect all four marks like mimaki

Attaching photo of what happened

I am cutting with CM5

I am new to printing profile and new to graphtec too.. At first instance, I gave a repeat job command to cut from a different file by mistake, Cutter just sensed the first registration mark, as on all cut files, then didn't find the other three marks, still go ahead and cut the sheet according...

curves are ok, just sharp corners is a problem

yes i did ..didnt work

i tried didnt help

sorry for typo error, want to say, as i have 1000 cuts in a small area, might take long if blade comes up and down 8000 times. wear faster. just guessing

I tried with all straight lines. joining the ends, and overtcut 0.004, didnt helped but didnt tried with actual overcut lines, i think it...

No they are same as before..messed up

I tried to set blade length with the condition3/3 #4, but not able to set it up. It keep saying 0.1 turn cw and i turn less than 1/2 mm ad it says ccw 0.2.. didnt worked I do it manually, scoring a line till it cut the entire material and no scratch on second bottom sheet. it works for me

Its brand new plotter grpahtec fc9000 160, I bought it last month. And this is my first cutter. Would have been a mechanical issue, its plotting everything else, perfect, Even i have files with 3/8" round 100 holes in a 36x36" print Even I print 3/8"x 1" rectangular 600 cuts per 36" x36"...

First I draw the square, drag in with holding down button, making this ocatgon. Even i try drawing an ocatgon with all sides same At last I draw all straight lines to make an ocatgon, still it did the same swaying cutting. if anybody has cm4 and graphtec fc9000 160, try this if works, i tried...