Recent content by gzolee

au off To disable Windows Update in the other Windows 10 editions, you have to set NoAutoUpdate to 1 in HKEY_LOCAL_MACHINE\SOFTWARE\Policies\Microsoft\Windows\WindowsUpdate\AU. If the corresponding keys don’t exist, you have to create them.

its printing Versaworks prints and cuts on windows 10, you don't need to use compatibility mode!!!!

before you replace it check the head cable and the fuse on mainboard. There is a service manual with a step by step guide how to flash empty mainboard.

they go hot they go hot but very slow but it is remaining on warming up

no errors at all no error code it is just warming up very long and hanging on warming up i check the firmware version tommorow but i think it is the latest which could be used with bulk inks. thanks frimware 1.03 i think

it does nozzle check but it does not the palette and if i set the heaters to 45C it is hanging on warming up. Thanks

Big thank you for all who has helped, i have a problem the printer is printig terrible its a vj-1304 and im using ergosoft my problem is this see picture if i turn the heater on in rip it is just warming up but not printing

go to maintance menu and first point if i remember and check the heaters if not working open it and mess with a volt meter, if fails change the part if good maybe relay. Google how to mess heater

Please help where can i find on the printer something to turn down the PLA2 becouse it goes to hot over 50 i have tried platen adjustment but cant set to 30 it says end warm up and continues heating, thank you my firmware is 1.3 runing bulk ink. The heater is on after i turn the machine off...

i think yes becouse i just get the piece what is 24 inch long. I let you know if i recive the part and have done it

this is from the 1204 manual 4.7.3 Replacing Cleaner Head (Cleaning Wiper) NOTE Before replacing the cleaner head, remove the following covers. • R side cover: "4.2.1 Removing R Side Cover" p.4-7 1. Remove the cleaner head from the cleaner head by using tweezers, and lift it from the holder...

sorted if you get this error get a volt meter set to ohm and test the heating elements if is showing numbers elemnt is good if not is down. Test the termistor as well but go to a radiator or close to something what is heating be carfull not more as cca 40 celsius and if is ok the numbers...

First thanks for all for helping me , im getting this error do i need to replace the part or its enaf to do something to get it working ??? Thanks

another soulition there is a easy card and easy hub is interesting becouse on the photos it look like it can be a diy job for me simple pcb and basic chip. Can you please name the software or upload it somwhere and som details what are readable on the reader and card. If i can make it diy i do...

if large format if you calibrate with eye one the basic pack does not includes the cmyk module