Recent content by jdwilliams1

In the event anyone runs into this we finally ran the issue back to this part MP-LFA15F-5-GJ1 - DC5V power supply. Once we replaced the noise went away and the motors ran perfectly.

Head scratcher! Have a had a couple techs come here and even more on the phone and we cannot find a solution. It ssems the gantry motors just started humming and vibrating none stop. They turn off when you put it into maintenance mode but other than that it vibrates and hums. The severity...

Ok so we decided to take this on ourselves and replaced both heads on our JFX200. We have actually been successful in getting the heads in and aligning them and the prints look great, however after our initial turn on after installation we started to get the whinning sound from our X motors so...

Hi Smoke, where are you located. We are in Indiana. We are a bit close on time and I should have 2 new head arriving tomorrow. If you want you can direct message me and we can discuss the options and costs.

Hi smoke...I do have experience changing the heads on our old jf1631 printers but have not tested my ability on the jfx200 just yet. Worried more about dialing in the colors probably although I have no clue where to start. I guess I'm also concerned about causing a deeper electrical issue by...

We have a JFX200 and both heads are just holding on. Looking for some tech recommendations or head replacement experts. We have the 2 heads on site. We have 4 printers so just want to be sure we can dial in the color matching as well once install. Thanks for any input.

Hey guys, I'm not sure if anyone else ran into this but I continue to have a communication issue where it appears that my computer is dumping my printer. I've tried to unload software reload it, and when I open up onyx, it sees the printer and it sits offline, i've double checked the IP...

This is for one sign but would it change your pricing if you were doing 3? 48" x 36" Sign Cost Breakdown Example 1. Material Costs Let’s estimate per square foot first: Size: 48" x 36" = 12 sq ft ACM Sheet (Full 4x8 = $50 / 32 sq ft) → ~$1.56/sq ft ACM: 12 sq ft × $1.56 = $18.72 Vinyl...

Hey Splash0321, really appreciate the response and I love the customer multiplier idea...genious!

Thank you so much for the response ProntoPrinter, this really helps. Couple more questions if you have time. So in this scenario, with the sign going indoors, would you hesitate using UV flatbed with no laminant? This is going in a golf course clubhouse.

I am interssted in what your general rule of thumb is on pricing. I certainly know it will vary from different areas of the country. But when making a sign are you generally using a multiplier on material assuming you are not doing installation? What about a delivery fee or do you hide that...

Hey Mark, I wanted to circle back around and see if you might still be interested in taking a look aat our printing issues and possibly some help with the laminator?

Newbie here struggling with new media. Is new media have to be entered in both the epson edge dashboard and the onyx system or in only one place. Sorry I know this elementary to most. I am not seeing Briteline in the system so I assume need to find something comparable. I assume our Epson...

So we are a product based business that has been selling wall decor and personalized gifts for over 2 decades and we would like to diversify as a sign business in our area and online. We have the following equipment 4 - Mimaki JFX 200 1 - Epson Surecolor s80060L 1 - Shopsabre CNC 1- Epilog...

Hello everyone. So went in to print on our jfx200 yeaterday and pushed the vacuum button and the light next to the button on the control panel came on but no vaccuum. Anyone ut there had this issue before? Just wanted to check before I start digging too deep. Thank you!