Recent content by jriley

What model printer? When you say you did a head soak, do you mean that you put some eco-sol cleaning solution in the cap (or on a lint-free cloth) and parked the head on the cap for a long time? When you say "now that it's back in," does this mean you took the print head out? What's the...

Lots of things. Bad print head, dampers, ribbon cables, fuses... like Joe said, need more details, and post a Nozzle Check too.

The "skipping parts" is the issue that has me concerned. I've seen bad cut ribbon cables cause entire portions of cuts fail to execute.

Back in the day when I used to toil on computers, if I had a problem like yours, the thing I used to do before troubleshooting hardware or deleting files was to take a look at MSCONFIG. I looked at all the processes running and startup programs. I turned off anything I knew weren't useful or...

Are the same exact nozzles in that magenta channel missing, even after cleanings? Or do they tend to jump around through several Test Prints? Any head strikes precipitate this problem?

Do you have access to one of those fancy line monitors that can generate a report on your power over time? I've heard low/inconsistent power can cause malfunctions that would otherwise be inexplicable in a printer. Plus, the E095Err PF Drv Err error you mentioned is also caused by low voltage...

How long was it sitting. From the Carriage, it looks like it could be a 1626UH (or some other non-solvent ink setup?)

Please, for the love of God, don't run your expensive, high-tech, precision printing devise in a dusty, dirty 'ol warehouse! :eek:

We need much more detail, including pictures. Details including, but not limited to: What model cutter? Are you sending the condition settings via the software, or assigning them through the plotter? What are your condition settings (tool, speed, quality, force, offset) What blade/bladeholder...

It's on the carriage. Your technician will have access to the service manual which provides step-by-step instruction on how to access, test, and make adjustments to the sensor.

Whichever printer you choose, it will run automatic cleanings while it's sitting. However, in my opinion, you should run some small prints several times a week--even if you don't have jobs. I know some folks have mentioned latex ink. Make sure to do some research on solvent inks as well...

You're probably going to need a tech to come in and check out your Paper Side Sensor. Probably needs cleaning or voltage adjustment.

In my experience, there's no way for a dirty or damaged encoder strip to cause your printer to shut off. Edit -- I just noticed that you've duct taped your head cables. Have you been messing with anything else on your printer? Edit #2 -- are your ink lines empty?

Greetings, sir.

For print only, consider the Mutoh VJ-1324x. For print/cut, I hear the Roland SG-540 is a good entry level printer. Both are 54".