Recent content by jus.hila

I used OEM...I saw a few members and people on youtube mention that the cheaper dampers don't last too long.

Hey guys. Just an update. Thankfully It was just the dampers and not a hairline crack on the printhead. I was able to change the dampers on my own. Thanks to Jim for sending me the service manual. Difficulty of changing the dampers was about a 7/10 ...keep in mind I've never done it...

I redid the test. Printed cyan file until black banding appeared. Printed cyan and green. There was banding at the beginning and then it faded away and started printing solid. Did the test print. Cyan is all over the magenta

Slight banding on the first half of color blocks. Test print cyan is all over the magenta

Btw is there instructional video to change the damper? I've been searching high and low on these boards and on YouTube. Can't find anything.

Here's the pics. Sorry I thought I attached it in previous post.

You may have to change the print head fuse. This happened to me, I blew the fuse because i was at the end of the roll and it stopped rolling and my print head just going over the same spot. After that nothing printed, I changed the cap top dampers etc and it turns out it was just the print...

another thing i noticed when I did a manual clean i did notice that i can see little droplets of cyan ink on the print head. Do you think the dampers can be part of the issue or does that mean theres a micro crack on the head?

I printed green and cyan and you can slightly see the streaks. I've also attached a test print. It's most evident when I print anything red.

Sorry it's a vs 300i

Here's the updated test print. It looks like it's the blue going into the red.

Here's a test print. It doesn't look too bad. Black only starts bleeding half way through the print.

Here's a pic of the test print. Doest look too bad.

Hey guys...just wondering if anyone knows what the problem may be with my Roland sv300i. When it prints red it print solid and half way through a large print the black starts bleeding into the red (see images). I've tried manual clean and numerous cleans and it goes back to printing well. Half...

Hey guys...just wondering if anyone knows what the problem may be with my Roland sv300i. When it prints red it print solid and half way through a large print the black starts bleeding into the red (see images). I've tried manual clean and numerous cleans and it goes back to printing well. Half...