Recent content by Krf1786

What are you premasking it with?

The stretch is off from the printer. Im assuming more stretching can happen from applying the vinyl to the dibond as well as the lam to the vinyl.. but not enough to notice. I do not have an application table. I use the same laminator to apply the vinyl as the lam.

I also tried the 3mm without an under layer btw (coroplast).. didn’t make a difference with the edges. Sent from my iPhone using Tapatalk

Thank you for taking the time for the lengthy reply. I truly appreciate it! Yes. The bits that the vacuum doesn’t suck up are what’s landing on the job. Another variable I failed to mention before is I’m using an 1/8” strait flute bit. I like how it leaves the waste in the channel so the...

That was something I was considering. My concern with that is being able to see the pieces being cut. “Fortunately” we seem to do a ton of jobs with borders and there’s stretching issues. The worst part of the stretching is there’s zero consistency. Sent from my iPhone using Tapatalk

Good Morning! A few things… 1. When routing ACM with IJ35+3M Luster Lam applied, does anyone run into the issue of the scrap material shavings ending up on the product that needs to be more than just dusted off? The shavings are tiny looking moon shapes for the most part but what I’m guessing...