• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by luisht

  1. Roland VS 540 ghosting image

    Here is another picture with the same yellow stickers I printed on the other test
  2. Roland VS 540 ghosting image

    I just received the new carriage board and replaced it. I can see an improvement, but I still get some magenta in the print, maybe the next step would be the ribbon cables. Now it looks like squares before it used to look just like the image printed (see attached)
  3. Roland VS 540 ghosting image

    Bad news, I replaced the sensor, and I'm still having the same problem, I attached new pictures
  4. Roland VS 540 ghosting image

    Thanks Jim, for the quick reply. The encoder I bought came with the sensor, I didn't replace it because I don't know where it goes. I guess I can try changing it and see what it does. I printed that file bidirectional.
  5. Roland VS 540 ghosting image

    Hello, I followed the advice, and cleaned it, with the same results. I decided to get a new encoder strip, replaced it two days ago and I'm still having problems, I attached a photo of a print I just ran this morning.
  6. Roland VS 540 ghosting image

    Hello, My Roland VS - 540 is printing a ghost image in a small 3'' section of the print, its in the middle of the print, I can avoid it if I print on the far left or far right of the roll, it happens on the same section every time, and it is usually magenta. I attached a picture. Thanks Luis
  7. Need Help Magenta drops out

    I did, my printer has 2 they are almost full, I'm surprised I was able to print 6ft print without issues on high quality, but when I go to normal, I get the same problem again.
  8. Need Help Magenta drops out

    Yeah, but when I run a clean cycle and then do the test print it looks ok. Its when I start a long print like over 18 inches, the magenta drops out. Right now I'm running the printer on High Quality and everything looks good.
  9. Need Help Magenta drops out

    Hello, i have a Roland VS 540, and it’s drops out the magenta about a foot into the print. I run a medium clean and it work again for another foot. I replaced the damper and the cap top. Any suggestions of what I can do next?
Top