Recent content by mkmie

I have never used that brand but it looks very similar to our Fletcher Terry and Kleen cut. We have cut 3mm ACM all the time. I usually score it two or three times and then snap it. My table guy cuts it all the way through with three passes. The Kleen cut has a couple of blade options. It isn't...

Am I the only one who thought Levelling was spelled wrong? Am I the only one who thought Levelling was spelled wrong? Had to look it up. US--leveling Brits---Levelling. If you were more experienced it would be better to wrap that. All that print, cut, weed, mask takes a lot of time. Printed...

https://wrappermapper.com/

I agree with everything you stated. I would like to add that it isn't necessary to buy edge seal tape. The end rolls of cast laminate can be trimmed to whatever size width you would like. 4 swipes on the Keen Cut and I have 18 feet of edge tape, I prefer 1/2" but have done 1/4".

Thanks for the answer. The not seeing out is a drawback but if it lets light in it might be workable.

Tell me more about white/white backlit perf, please.

I thought this was an AI until the "happy go-getty". Does AI speak like that?

https://us.digiprint-supplies.com/en/ They are a merchant member.

That's a book mark from Amazon. I like to tell my customers I can not "blow up" a postage stamp to a banner.

Lost this guy three years ago at 16 years old. Herky the wonder dog. I never thought he could be matched in his cleverness and spunk. Like many of you, I thought we are too old to get a new dog but the kids said they would take over care if we need it. Meet Tayto the wonder dog in training...

jason@hbmsupply.com http://hbmsupply.com/

The sh*t we put ourselves and loved ones through. I don't know you but I am proud of you.

https://wrappermapper.com/ I have used this to get wrappers in other locations. Avery and 3M definitely have a data base for installers. I know this is only useful for contractors but as damonCA21 said contract installers earn more and can pick and choose the jobs they will take. BTW I never...

I haven't seen an untinted window in 20 years.

I didn't see where Geneva says it was for a vehicle application. If it is on a vehicle it must be laminated. We use Avery 1360 but have also used 8518 when we used 3M. Both are good. If it is a storefront the least expensive optically clear that I know of is Gen Form 105, about 40 cents a s/f...