I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hello
I am wondering if anyone has replaced the web wiper assembly. I got this error a week ago. I proceeded by the service manual instructions and the results were I should replace cleaning station.
After replacing the printhead cleaning cartridge, I ran about 80 sq ft of print with no...
Does anyone know what adjustment i should be looking at if the plotter is cutting 1/16" short in the front to back direction over a 4 foot span. onyx production house software. hp l25500 printer. oracal 3551 media with laminate. Is there an adjustment for front to back travel or anything in the...
media loading
I have a bunch of extra media fed out. It is not jamming from head strike. it is tearing from something in the hold down area behind the pinch rollers. it is only doing it right before it prints after cycling media up to temp
Was wondering if anyone has had this problem. Media loads fine. Printer starts to warm up media with heaters and cycles media back and forth. Then right before it gets to the right temp when the media gets soft. It looks like something on the right side(facing printer) tears the media and then...
Thanks Pro Color
My email Address is mysignguyz@yahoo.com
I have the belt ordered. I was trying to track down a part number for the pulley on the control side that the belt runs thru. hp people wanted to charge 40.00 to tell me a part number even after i had ordered the other parts from them...
Belt did break part number?
Does anyone know what the part number is for the pulley assembly that is located on the controller side of the machine that the belt runs thru? it is intact but might as well replace it at same time.
Has anyone every replaced this belt before
thanks heads are now covered. A few more questions
Thanks for info to secure Printheads.
Now does anyone have a good source for parts for this model? Is there a place where i can download a service manual or has someone replaced one before?
Is this a common issue with this model, The printer...
While printing today the belt that runs the print head assembly broke and the printer would not shut down properly. Has anyone had this happen to them and if so how did you get the printheads secure till it could be fixed.
Thanks for any help with this issue
Jamming Media
I just started having same problem with ij 180 c 3m material. It appears that the 2 of the plastic hold down tabs behind rollers are bent down more than the others and this is the area that i am having problems with. I am assuming that as it heats up material and it gets soft, It...
When your printer goes into sleep mode does the small fan on the front keep running? It is the single vent on the right side when facing printer... Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.