Recent content by Pinfinity

We are working with HDU. This is a carved sign that has been primed with Styx primer. Can we apply Luco gold size over the primer and expect good adhesion? Help would be appreciated Thank you

Thank you ...appreciate it much

Looking for the name of this font..thank you

Im hoping on the pros here to advise on painting pvc post sleeves. I know pvc can be problematic but we recently purchased a Benjamin Moores COMMAND black paint. We scotch brited the pvc sleeves cleaned and commercially sprayed out black onto the material. Idrues fast and adhered very well. Im...

Hello Can anyone help me with the attached font name type? Appreciate any assistance Thank you

Thanks much, BILL..we are CNC routing a few signs in HDU and just looking for the steps in masking painting etc.

Wondering if anyone can lead me in the right direction with a few how-to videos using Smalts . I have scoured youtube and a few others and nothing in depth Any help would be greatly appreciated....thanks

Gino, thanks so much for the info. Sounds like you have found the answer to this. We have tried everything to avoid leaving the adhesive residue left from the yellow PASK masking film. We just finished painting a 4x8 1.25" Exteria carved sign. Sand background material, prime using STIX. HVLP...

Any help is much appreciated. We have been using Pask yellow paint mask for carved signs that have been primed and finished using Aquacoat and or latex enamel. We let the paint dry for at least (2) days, and apply the mask and paint. The problem is the glue residue left on the sign when removing...

We are working on a project using Extira with CNC carved copy. We use Stix primer and finish with Aquacoat ronan paint. Is there any way to avoid tearing out when removing the mask? We are filling the graphics with modern masters gold. Should we be using enamel vs water-based paints? Any help...

Thank you very much, Fred Its been a while since I posted anything so I'm a little rusty. Appreciate your help Dennis

Can anyone help with this font identity...much appreciated

Can anyone help with this font identity? Much appreciated

Can anyone provide help with the print issue with this printer? I have run several cleaning modes, soaked the printhead, etc. The only part that has not been replaced is the maintenance station. This printer was working fine up until a few days ago. The firmware has been updated. Was having...