Recent content by pjs321

I have just been told that the circuit im plugged into is not very good and has been fluctuating a lot. So it seems that could well be the problem. We are going to isolate the power supply and go from there. Many thanks for all the help. I will post how things go.

Thanks Chris The lines are printed on both passes. Print modes are high quality 700 and high quality 700 uni As per your description i have mixed the x and y axis. The fence the carriage runs across has been replaced and not the circular encoder. I have replaced the cables that go...

Its strange how it only prints the lines on the bi direction function. It even prints the lines before it starts any print (over white space before a print) and its all 6 available colours. No lines are printed at all on uni direction.

Problem still there after cleaning both y and x sensors.

No sensors have been replaced. I wil try to get cloth inbetween. Many thanks

Thanks for the prompt post jhilldesigns The y axis encoder has been cleaned and the x axis (what i have been calling the timing fence) has recently been replaced. I was getting a lot of error 72's and after cleaning the circular y axis encoder the problem stopped. Do you think this could...

Hi Im having problems with my Mutoh valuejet 2606. IT leaves vertical lines all over the print. Sometimes its really bad but it comes and goes. I can print fine on uni directional. Picture link below is the worst its been. In order to try and solve the problem we have already replaced...

Hi Im having problems with my Mutoh valuejet 2606. IT leaves vertical lines all over the print. Sometimes its really bad but it comes and goes. I can print fine on uni directional. Picture link below is the worst its been. In order to try and solve the problem we have already replaced the...