Recent content by radarlover

Thanks Ragna Pandoras box would be about right, taking your advice I pulled the carrigae cables from their respective receptacles where they go on to the carriage board and then reconnected them. So now test to see if there is any improvement, rather than change anything else and then not...

Hi it runs with the carriage and is one jet wide definately magenta, not the whole way but intermittent, then it may clear for several passes and then do it again further down the print but not necessarily in the same place. Just flushed the heads through again today with cleaner and...

Hi all ok I have an sc 500 and just started a new run of decals and noticed a thin red line appearing through the decal. Have cleaned the encoder strip still doing it. It looks to be one jet wide and does not go all the way across stops and starts ???????? Have done cleans and demos...

Hi all have been dong some research on dye sub printing duringwhich I have noted the use of polyester material fort shirts etc . I havelso read that it is possible to use a mix of poly cotton. What I can't seem to fnd is detail on the best ratio mix of these two to give the best...

pdf/png correct J Hill as far as the pdf being the png converted. The issue here is that the Graphic artist that this guy has enlisted said that it was a svg, so obviously the GA is in the dark . hmmm I suspected initially, that either the guy had created the artwork himself, or maybe...

Hi All typically I have been trying to get to grips with printing for some time. I bought an ESX 54 in machine back in 2013 and now some of you are thinking oh no. Anyway a guy mailed me a png file of a design, he had his graphic designer draw for him. It contains a graphic, with...