Recent content by rcook99

Its similar but not a match. Hope someone can figure it out. Thanks for trying.

The closest I can find is FRIZQB in signlab. Nothing in Corel. Hoping someone an help me out with this font.

I tried matching it in Flexi and Corel without any luck. Hoping someone here can direct me to which font this is in the picture.

Thanks for your reply but I found a supplier and had to get them ordered with the limited time frame I had.

Looking for someone that can UV or screen print about a 200 plastic license plates for a job I am quoting. Also a supplier for the blanks would be helpful. They are 12" x 6" and will be 2 Thanks

Deleted

Never had issues until recently doing 30" wide material. So now I am looking at a Royal Sovereign or GFP laminator for a replacement. Will look at 30" but may end up going bigger as the 30"gfp does not load as easier as the larger version of GFP. The 30" requires an allen wrench to change media...

I used Germ X to take it off our stainless refrigerator after one of the kids accidentally marked it up. Worked very well.

Ah okay, thanks for clarifying. Was looking at the 30" GFP and noticed they don't use the same roll holders on the 30" as they do on the larger laminators. The larger ones slide on and the 30" has one on each end of the roll holder that has to be put on with with allen head screws. Seems like a...

I would guess they make adapters for the 3" material, but I will have to check to be sure. I assume your GFP is 55" based on model number. There is a used 30" GFP about 3 1/2 hours from me for sale. Wish it was closer so I can go and run a test on it to see how it does instead of traveling that...

I have a 64" USTECH that I bought new and has started giving me issues with bubbles when laminating 30" vinyl. I may be at fault for leaving it loaded at times. Keep in mind I only run 30" material as I don't prefer to do larger signage at my age. LOL So I am in the market for a new laminator...

I recently built a new desktop system. I am wondering if there is any certain order I should load my software listed below? Any help is appreciated. Wilcom 4.5 Signlab 9.1 Adobe CS5.5 Corel X7 Flexi Cloud

Thanks for the breakdown. Was reading on the nvme drives as it’s been 12 years since I built my last one. It still runs well but was time for an upgrade.

The 500 SSD is just for the OS and other programs, all other files will be stored on regular drives set up in raid as well as an offline HD backup. What do you recommend for better storage?

No it’s definitely not a gaming computer. Just for sign and embroidery work.