Recent content by rx7boy

Hi Matt, thanks for looking I have gotten into service mode and done all the necessary calibrations now thanks again for checking. I will probably send our old board back for service, will keep you updated on what that costs us.

Hi Matt, just recieved our replacement board, did you get any special instructions on replacing it? There is a QR code to scan for instuctions but says we are not allowed to view. Just not sure of any special steps you may have followed, the board is in the machine but just getting surface...

Thanks Matt, great to hear I have ordered one from ND graphics here in Canada as they are our supplier. Wondering did you send your old one in for repair to have a spare on hand?

Hi Matt Just wondering if replacing the main board fixed your problem? We are getting exactly the same error on our F1612. E10016 internal error 5 Thank you John Boylan Boylan Imaging

We switched our Fuji Acuity (Arizona 350) to Lipla about 4 years ago and their ink is awesome. Also their service and expertise is great! We are located in Canada and they have helped us over email and messaging with any machine issues we have had with fast response times. They are genuinely...

We have hp r1000 and love the white in it, basically the same system as the HP 700w

Hello I had the same issues and I just upped the overcoat from 0.5 to 0.8-1.0, that fixed the issue.

I would have to somewhat agree and disagree with parrott. We started years ago with just a Latex roll to roll then added a used Arizona to our lineup in 2019. That was a great addition and investment. We then were looking at getting a new roll to roll and flatbed as well last year but decided...

Welcome! Medicine Hat, AB

Hello we to had this issue bad and it seemed I followed what everyone was telling me to lower the heat and vacuum as much as possible which did help but had head crashing because of lowering the vacuum. Then our on ramp tech came at about our 4 month period from installation and all is good...

Hello We have the holographic material and print white ink, maybe we can help you out. We are in Canada but never have problems shipping to the US. Do you have more details of the stickers? Thanks John

Are you using the special 3M installation tool with the heat gun to apply them?

Thanks RJH, so with your template or skid you are placing coasters in there individually I am assuming that are already precut? We are printing the full 40x60 sheets then cutting them on our summa. John

Much appreciated, I will reach out to support for the registration issue and thanks for the tips for the coroplast

Hey everyone on here. We finally bit the bullet and got an R1000. 2 things I am running into and wonder if anyone has any insight. We run a lot of 2 sided coasterboard .045 and we are having a heck of a time getting registration to line up. On our Arizona it’s never an issue. It seems the...