Recent content by Salmoneye

I need two sign faces. Direct print, single sided 60"x120" lusterboard faces for pickup in Riverside County Ca. Anyone have a good recommendation or want to print these for me? 951.719.6975 text, call or leave message here

I will have to do a little poking around, I don't even know where the main board is located yet. Probably need to take some static precautions too, there seems to be a lot of it here right now. Thanks.

Bump, Anyone? I still can't print. If I turn it on I just get a cleaning cycle starting. My limits are out of whack and I will need to get a limit initialization started.

Finally got the heads parked by turning the belt that drives the capping station with a screw driver (can't find the head parking tool). If I turn the main power on again it's just going to drop the capping station and try to clean again and give an error instead of entering limit position...

Yes, I am pushing all three while turning on the sub power. I have also tried pushing all three while resetting the main power and both ways it just attempts a cleaning cycle then gives me the error code.

I tried to run a limit initialization and somehow screwed that up. Now, every time I try to enter LIMIT INITIALIZE mode it instead goes into cleaning mode until I get a Service 0101 error. Any ideas how to get back into initialize mode so I can try to run it again?

Thanks all. I don't mind paying a bit, someone had to do the work. I would make my own but the bike is not where I am. Thanks again.

They make corkscrew like augers to hold down mobile homes and the like in high wind areas. They would penetrate the ground but not really disturb or dig up much if any earth.

My kid wants me to make him some graphics for his 2008 YZF-450. Anyone know where I might get a set of templates that I can use in illustrator?

Nobody wants to make these for me or knows a merchant member that will? Maybe I posted this wrong or something?

Hi guys, who can make me (3) 6"x36" aluminum or poly metal sign riders and blind ship them UPS or FedEx to my customer? I will send an .eps or .AI file with artwork and with or without cut lines for border. Please PM me with vendor info or quote.

Not sure if this is the best method but I would take a long piece of paper or backer and first make two marks indicating how long the lettering will be and then mark a flat baseline. Wrap that paper around / over the curved item that you want to letter (car windshield, bucket etc.) Put the...

I would think that the extra thickness would and layer of adhesive would cause more failure from expansion/contraction etc. Might not fade but it would probably be more likely to fail.

The above post is correct. You can set up a base point or set up as a piece or roll, they will all work.

Welcome to Amarillo.