Recent content by saratoningraphics

This is with air release vinyl. The bubbles are so bad, I cannot squeegee them out afterwards... There is A LOT of air left throughout the entire print. Sometimes it will just be a little bit that I can squeegee out the air but for large prints, I cannot..

All substrates are cleaned with alcohol and a mircrofiber cloth before applying the vinyl. I never used my other one to apply vinyl on boards. I know its a bit weird, but I do not want to use my first laminator for anything other than laminating film to perserve the rollers. They are both 60"...

I bought a second laminator so I could apply my laminated vinyl prints to substrates. It almost always leaves large bubbles where the vinyl is not applied to the signs. Even if the bubbles aren’t visible, if I take a squeegee I will see a bunch of large pockets of air. It’s so bad that I’ve had...

Best way to deal with the recessed area without the vinyl failing?!!?! I designed some wall graphics for a gym...What's the best way to go about the recessed area. Its deeper and larger than the average grooves. The print will have to be printed in two pieces because it's wider than 60". It...

This would make it so much easier, but I was told they do not want anything going through the face of the sign... I'll suggest it but they seemed pretty against it. Thank you for your advice!

Thank you! If the customer choses to continue with wood I want to recommend an adhesive to use but I might say they would have to do the adhering so there is no warranty the sign. They probably want to save money and use wood they have laying around, but hopefully they will consider PVC so they...

Thank you so much for the adhesive information! I will be trying to persuade them to spend the extra money rather than using wood.

Old sign needs to be remade. (About 1 inch thick) *ALL MATERIALS WILL BE NEW* I was told I could just do the faces of the sign and client would make/cut the wooden center that the faces will be attached to. If I make the faces with aluminum or ACP, what is the best way to attach them to the...

Thank you. I was considering getting a quote from them.. This is just such a basic sign I was hoping I could find a "blank" that was available for purchase, but I am sure Gemini would be able to provide a blank sign too.

Where can I get a sign like the one below? My client wants the following: -24" diameter circle led sign -Material needs to be acrylic -Halo lit without light coming through the front or the lettering/logo -Must be able to plug in and turned on by either a switch or remote (Cord will not be...

2024 and I am wondering the same thing......

SOOO I thought this was working and I kept adjusting until I got it perfect... for the first row. by the time it got to the third row it was off again... worse than it was before...

Thank you so much! I saved this for future use!

THANK YOU!!!! Something that finally helped without spending more money!

Thank you for the replies... brand new blade and cutting strip did not make a difference. It is still slightly off and I am not sure how to fix it.. Wheels are cleaned as well as the entire surface. I am unsure if it is off from reading or if it is off because of the pinch rollers. Here is a...