I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
This turned out to be the case. Checked the fuse again and everything works! Prints like a new machine! The fuse can check good and not be soldered to the board properly. Thank you for all the advise!
Steps completed to repair printer:
Replaced fuse (everything is good), replace damper, cap, printhead cables and finally the printhead. Still no black or cyan. I checked the larger transistors and all are good. Has anyone any suggestions at this point?
Update on the Roland SP540v:
Replaced fuse (everything is good), replace damper, cap, printhead cables and finally the printhead. Still no black or cyan. I checked the larger transistors and all are good. Has anyone any suggestions at this point?
Thanks for the valuable information. Checked everything and all was good. I will try a new printhead and hope it works, if not I will post a boat anchor in the For Sale section.
The problem started with the black going out. Cyan, Magenta and Yellow printed perfectly. I replaced the caps and the damper. still no black. I primed the damper and checked the seal on the caps, all good. Then I swapped the ribbon cables and the fuse blew. Replaced the fuse and now no black or...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.