Recent content by tamif

ok thank you for your help.

I have an HP latex 315 and need to get a new spindle hub. I have found some that say they are for the hp design jet. There is little to no difference between it and one made for the 315 (other than price). Does anyone know if it will work? It is 3" which is what I have now.

I usually put a piece of polymetal underneath.

I currently have a hand crank laminator (hoping to upgrade soon). I have to put a hard surface under my material before laminating. I can’t just put my print in and run it through bc it leaves a lot of bubbles. Is this just bc it is a cheap hand crank or am I doing something wrong?

I have a 24" printer I could use. I was just interested in the small table top machines that only did decals/ labels.

Does anyone know of a small machine that will print and cut small label stickers. I need to be able to print and cut multiple designs. Would love it if it also laminated, but I figure I am asking too much on that. I am a small business so it would not be high volume. I am doing them on my 54"...

I have a logo from a customer that has a lot of shading and color to it. I have managed to pull it into adobe illustrator and keep the color. When I try to save it or pull into Flexi it dulls the lettering from a bright red to a dull brownish colors and most of the time it leaves harsh lines...

I have an iprofiler pro that I use, but it doesn't seem to help much.

I am looking at getting a new computer. Do I need to be dead set on a particular graphic card? I am printing on an HP Latex 315. Is there a graphic card that will show closer colors to what the printer puts out?

Thank you. I appreciate your help.

Would this printhead be the one that is not working right? It looks a little different from the others.

Ok, I thought the test prints looked bad because they were all splotchy. I figured they would print smooth like regular prints. I have only had one time where the blue printed better and it was just after cleaning the printheads, by the end of the print it was going back to grainy. Other colors...

The roll is brand new. I tried wiping the material with alcohol and printing on it after reading that it could be the vinyl. It didn't seem to make a difference. Should I just replace heads with the blue in them since all my sensors say they are all good and the test print showed all of them...

I have started having problems with my prints coming out grainy. It seems like dark blue is the worse. I have had prints that were real nice and then the next one is grainy again and some that the yellow prints fine but the blue part is grainy. After reading up on it I have checked to make sure...

Thank you so much.