Recent content by Technician

Contact, Ernie Viveiros he’s aktiv in FB group Roland Digital Printer ** Support Group ** If I remember correctly , he is based in Florida

First of all. You should check for miniscus air leaks. It should not fluctuate up and down like that. Then all your filter for the protection of the miniscus vacuum system should be 0,2 micron. Nothing else. Then you should make sure your degassing system works. That means to check everything on...

deleted??? Have you already tried?? It costs you nothing to try. Cut server can be used with out license

Download cut server 24 and try

so, when you change the z motors. Did you do the Z-Axis Relative Offset adjustment?

Step 1 is to make sure your degass system works. The printhead you have in that machine can’t handle air in the ink. Do you get same problem if you print same job on paper?? If not it could be static problem. When you get the problem how does it look on the printhead plate?? And of course it...

There is a bulletin about this and a modification. Talk to your technician about it.

Go for s2

check out https://www.polychromal.com/ I think they have what you’re looking for

I think you should take a look at this printers. You get a print that not laying on top of the plate like uv does. https://www.polychromal.com/

And if you laminate you can use cut from backside

I forgot also ceep inside was selected

Multi pass 1.5mm and 400mm/s. I think I use 0.4 in compensation And yes the knife tip is intact Better results if not cut letters with round corners.

ACP and Dibond is your only option Route to get nice results. The pvc. Is the PVC foam you talk about? If it’s same as Forex then you can use single edge cut out knife. But 10mm you need to use router. I have done test with POT in 5mm Forex and doing smaller letters and it doesn’t look god.

When they changed printhead first time. Did they check circulation system works properly? Do you take out white ink bag and shake/mix it every day? This is mandatory of oem ink. if you’re experiencing curing problems, make sure you have fresh lamps bulb and clean glass on your UV lamps and...