I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
I usually do a gokart from design to finish in about 2 hours and charge around 350 to 400 depending on speciality films. Pretty decent money for me but to each their own. I find gokarts more profitable than those dang race cars.
I'll send some pics of a few I've done to give you an idea when i get to my shop. Get aurora graphics. I use photoshop because the gokarts are small and pixelation isn't bad for such a small wrap. Most use illustrator I believe.
Bob when it does cut it's off the the mark so if I printed a black square and contour cut it it will cut a half inch of the black off on the left side and leave a half inch of unprinted media on the right. I am using automatic registration marks. The plotter attempts to read the marks but...
I have reset the plotter. It's on all files and it's only when I contour cut. I have received a message on the plotter a couple times that reads arms out of reach.
I have a mutoh value jet printer an a graphtec plotter. I have been contour cutting for close to a year now with little to no problem. About a week ago the contour cut started to either not cut at all or would not cut the desiered cut area. Any advice would be much appreciated.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.