Recent content by Umca

Test print means Nozzles Check from printer's menu.

First check: Make sure the printer is turned off. Manually move the carriage to the center. Then power on the printer. The covers should be either closed or bypassed. The carriage should move slowly to the home position. If it doesn’t move, you likely have a problem with the motor or the motor...

If you turned the printer on and it detects the carriage not in the Home position, the carriage motor activating until the carriage will reach Home sensor. CR encoder does not using withing this moving. Just slow motion by the CR motor. You can use this for detect if it the motor problem or...

Check ink line. Maybe cartridge needle is clogged. Because one ink line from the cartridge is splitted to two heads.

No, It looks the material has a waving on the printplane. You can see waves what for sure touches a printhead while printing. Maybe, overheat of the media or wrong temperature setting for preheater.

Maybe wrong cable order?

Yes, It is still installed somewhere on my old PC. And it was not free also. It had license key with some features activated depends on configuration.

I remember this cutter had EasySign software in the package.

I tried them. It was like a lottery for me. Many either didn't work right away or broke down very quickly. I chose the path without chips and forgot about all the problems with them.

Most probably one of power transistor which mounted to black radiator burned too. Check them.

Yes, PM

Finally I found the picture...

No. It is ink ID board exactly. The sticker on cartridge looks like mirror self-adhesive vinyl about 5x5 cm with black squares about 1x1 cm. The sensor detect reflection difference depends on square location and the printer accepts the cartridge. Low ink sensor located under ink ID board.

The printer does not have smartcards on the cartridges. Just optical recognition by label (mirror and black squares). You can made them very easy.

Not correct. E084 Y2 it is about CR axis. For sure.