Recent content by Windcalmer

That is a great point. I have moved it around. I will check that first thing tomorrow.

The substrate isn't bowed from what I can tell. I have checked each of the jobs as they come off and look good and straight.

I have a FMJ-1600II laminator that I have been using for 6 years now and I am having an issue recently. I use it to lay 4x8 sheets and 4x10 sheets. I use 3m IJ35c-20 with 8520 over-laminate for most jobs. The issue has been that the last 5 or so signs I have run through have come out perfect on...

Ok, I was thinking it was generational thing. My other JV33-130 has the fuse holder like the photo on the left. It is also blown, so as soon as I have replacements here I will get them installed and see what I get. Thank you for the fast reply!

Mimaki JV33160 Went to change the head last week and then the printer would not power up at all. Relays click, but nothing. So I do a ton of reading. I figure it is most likely the head fuse. And this is where the confusion starts... From everything I can find online the head fuse is a...

This is the windows of the production manager properties as accessed through RIP & Print at the top left hand button.

Quick run down: All of the sudden today I have RIP and Print showing registration marks, however once I send it to Production Manager there are no registration marks. I recently had to delete the Mimaki JV33-160 from Production Manager and add it back in due to a USB issue I was having. It...

Rock and Roll. Thanks for the reply.

Can anyone tell me what this setting does? I have searched until my head hurts and found nothing.

I have a FMJ-1600-II and use it for laying vinyl on large panels. It has been good for about a year and now every time I lay vinyl on a panel it has bubbles on the right half on the panel. I have tried to level the rollers as best I can by feel and it still happens. Do anyone know what could...

I come here to hang my head in shame and lift high the dunce cap and place it upon my head. It turns out that it was not in fact my printer making the beeping sound. It was my UPS that I have attached to the printer shouting that I was overloading it with all three heaters turned on. I learned...

No, there is no error code. I also checked the ERROR LOG in the settings and there is nothing recent. The last code is from when I didn't have all my ink in like months ago.

If this helps, here is a video of what it is doing.

O.K. I have another thread right now, but this is a totally different problem, thus a new thread. I had a broken post heat thermistor so I ordered a new one and it got here today. I got it installed with no issues. So I boot the printer back up and go about setting the temps on pre/print/post...

So the newest roll they sent is exactly the same as the last bad roll. The manufacture dates are months apart too. I am trying to tweak my print profile to get a good print without it being wet so I can get a few jobs out the door. EDIT: I was just sitting thinking through the day before this...