Recent content by woidstyle

I applied the contact spray now on the connectors. I will leave it drying for a week now and will check again!

Thanks will try it..

Sorry but I was looking for German speaking person here due to better communication possibility.. I was wondering if it is possible to get the green connectors on the printhead as spares.

Man kann ja fasst keine Fehler machen beim Kabel einstecken oder. Es passt ja genau! Ich finde es schade, dass man die grünen Konnektoren nicht als Ersatzteil kaufen kann

Hey everyone thanks for your helpful advise.i now have ordered new cables in order to try changing the cable. Maybe it helps. There is a spray here in Germany for cleaning contacts and electronic boards. Maybe I can use this and spray it on the connectors of the ribbons. And let it try of course..

:-) Sure that counts.. The cable is quite new, however i will try again with new cables and see what happens..

I just wanted to clean the print head properly. I will now try with new cables and if this does not work the only chance will be the print head..

Hallo Frank, besten Dank. Aktuell habe ich das Problem dass mein linkes Magenta immer feuert. Auch wenn es gar nicht sollte.. Ich weiß nicht, wie ich dieses Problem lösen könnte.

Hi, alltogether would be very happy to get to know any German Mimaki experts due to some problems I am facing with my CJV30-160

see here the video: https://we.tl/t-AnnrZKZsZ2

Thanks for your feedback. Just a visual control of the cables? They are quite new so I am not sure if it is the cable. See here a video of the test print as well as it keeps firing! May there be a problem with the capping station as some say it is the damper and some it is the capping station!

Printer model is CJV30-160

I built out the printhead and flushed it. I then connected again the cables and that's what it is right now. Before I had an 205 47v printhead error. I replaced the f13 fuse then it started booting again but now I have this problem..

Hi guys, can you please help me with looking at the photo attached. During test print the left magenta keeps on firing all the time. Anyone knows this problem?

Hi, after changing the fuse I have another problem. The left magenta keeps on firing all the time during test print!