I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Hey sign Gurus,
I don't have a part number but the bit is 150 degrees x 1.25" diameter x .25" shank.
Can you guys link me to a chart or recommend a starting point....will be using it on PVC.
Yes, I have an air nozzle blowing on the cutter and the vac running to attempt to collect the chips but they fly everywhere and I am also following the cutter my my hand held air gun blowing the chips out of the cut valley
So here is my first run.....I got the 1/8" and the 1/16 bits making nice smooth cuts but my 3/8" ×4" onsrud 52-574 is very noisy and chattering....I was did 1 pass .375 deep at 180 ipm/18k rpm and another at 130 ipm/13k rpm and got about the same results
I also don't use mil....I would say...
Ok so to answer all the questions already asked.......
I am using a multicam 3000 router/ enroute 6
Cutting letters into a 3" thick slab of "sign foam" as called by my supervisor.....I will try to find out its specs....
I have a 4" 2 fluted flat bottom bit that has been nicknamed the "ron...
Hello Sign Gurus
I am the new router guy at my job and coming from drill/tap/milling, the real artsy stuff is not my forte.
So far I have routed aluminum, acrylic, pvc, and and melamine basically a lot of flat cut letters and shapes.
Next up is 3" sign foam and I don't even know where to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.