Search results

You have a siphon problem. Check the dampers and o-rings. They work like a valve that creates a vacume when you stop printing so it does not drip. You may have a leak from when you used the syringe. If you didn't use the syringe on the black and it doesn't leak that could be it. You may need to...

Do the powerful cleanings as last resort. That uses a lot of ink and can damage the heads. They dry out because air gets into the caps. You should do a flushing adjustment once you get it working again. That will adjust the positionof the caps and may help solve the drying problem. But they...

Caution When you add the cleaning fluid do not put to much in the cap or it will flow down the sides and build up where the springs are. Then you will have problems with them sticking. Fill it just under the top so the fumes do the cleaning. I had to clean out the cap bases using a q-tip and...

blast They took the head out once and hooked up a tube to it and blasted cleaning fluid through it. It does work. But I ended up getting a replacement head for it because it was scratched and there was a deflection problem on one of the nozzles. You have to make sure the flushing adjustment...

I don't use all the time My machine is not used that much and I always clean it up after each use. They say you can not use it for a month at a time but it dries out in a couple of weeks. I had heads replaced under waranteee a few times and they replaced the seals and it still happens but not...

I am sure everyone has had the problem of not using your machine and having the heads clog. Here is a tip that works real good. 1 - Remove the front cover 2 - Cut a few small pieces from your drain tubes (1/2") 3 - Unplug the t fitting and use the piece of tubing you cut and a plastic...

fixed Thanks for the help. The problem was fixed by changing a network cable location. I had to reload the software on a new drive and one of my network cables needed to be changed to a different port on the router. Even though the software worked before with this same port and cable...

will not connect Before it said network not connected or communications settings not correct or something like. I was now getting a message saying dongle not properly attached or printer setting is invalid. So I removed the versaworks software and deleted all versworks in regedit Then...

I had to reload Versaworks on a new hard drive using the same computer as before with a reloaded XP OS. When I load the software it doesn;t recognize the IP address. I tried to manually set the setting for the network card but it doesn;twork . The card works for the Internet so Iknow it is good...