Search results

When this happens it is due to a bad cable or a bad signal. If you have already changed the flex cable and you have the same problem, I think the next step is the head, if it were a slider problem, it would not print anything. when you changed the flex cable did it have ink ???

What you should do is clean the station where the wiper runs, and lubricate the gears. If this does not solve the problem, you should change the maintenance station.

Hello You have to be very careful when you change a manifold because if the o-ring is not placed in the correct way ink can pass through the electrical board in the printhead and cause a short circuit and this will be more expensive than just a head. some times the cheap way is the most...