Search results

I'm having a weird issue with cutting from the L25500 on my Graphtec FC8000. Using Onyx X10, I am able to get the cuts aligned at the start of the print, but then it goes off as if the print is too long or the cuts are too short. Left to right alignment is ok so I don't suspect any bowing...

He was thinking granite at first but $$ was a bit too high for him in his research (prior to contacting us about it).

I have no experience with corian - how does it hold up to UV and pressure washing?

Oh yes, I forgot to mention, they don't want wood.

Hey folks, I'm looking for some cool ideas for the course markers (2-3') by 1' hanging signs. Customer requires hole number, yardage from the different tees and an outline of the fairway on each sign, there are... you guessed it... 18 markers needed. Customer is looking for a long-lasting...

Royal Optima is a website based in Indonesia claiming to be a wholesaler of a lot of brands of equipment at some (too good to be true) low prices. Anyone actually dealt with them?! My scamdar is going off bigtime, but it doesn't hurt to look into it a bit before writing it off as fraud...

The transistor was an A1746. I've sent my board away as buying a new set of transistors and having them replaced locally (with no guarantee) was roughly the same price as sending it to MacMedia for their guaranteed service.

Ok - an update! The fuse is blowing when it's installed because one of the transistors has failed (so it blows the fuse immediately when power is put on). I'll be looking at buying some new ones. Anyone know of cheap suppliers for these? I know macmedia has them, but I'll replace all of...

Yes - the M/Y head is firing correctly. Doing a cable swap of both cables (switching the cables completely from one head/connection to the other) results in M/Y head continuing to work properly. I tried attaching the cables from the K/C head to the M/Y connector, but then I get a temperature...

Not to hijack this thread, but I'm running into a very similar issue. Long story short, I was getting dropout on my black and after repeated cleanings it wasn't doing much better. One final cleaning by putting the syringe with cleaning fluid on the manifold resulted in some liquid leaking out...

Hi folks I've had some dropout on my black printhead so (after lots of other things) run a cleaning cycle and then I completed a pump out to clear the lines completely so I could see them. They look great, but now I can't get any ink into the lines again. I'm running new carts and I've tried...