Search results

Got a couple more fonts I'm having trouble identifying. I don't have either of these, the font for "apalachee..." and "rock salt..." Any help greatly appreciated. Thanks,

Trying to identify the font for "emr" Anybody know what it is? Thanks,

Can anybody identify this font? Thanks,

On ACM panels, the protective film always says "install in one direction" with arrows. Might be a dumb question, but what does that mean?

Just placed an order with Casey, got an inferno on the way. Can't wait to try this thing out, might have to put a seatbelt on my desk chair.

80'x14' wall wrap, ceiling to floor. They requested that we do not use low tack vinyl as they have had bad experience in the past with it. Wall wrap will only be up for 3-4 months and they don't care if there is any damage to the drywall when it is removed. Wondering how others would go about...

Will be installing an 80'x14' wall mural soon and wondering if a big squeege would speed it up much. The panels will be 52"x14' installed vertically, and go from ceiling to floor. Have read a lot on here at how well the big squeege works, but have never used one myself. Would it work well for...

Looking to bid on some of these crosswalk signs, and trying to figure out if it would make sense to keep them in house. What is the normal means of producing these? The fluorescent yellow-green and white parts are DG3 reflective, and the black and red parts seem to be opaque. Can the...

Roland xj540 printing yellow blocks and vertical lines. Seems to be in the same horizontal area of the prints, but different patterns of blocks and lines. Just randomly appears. Printed the same file a few times and got the blocks in different spots vertically, but pretty much the same...

Anybody know what font was used for Haslam?

Anybody know the font for Long Gone?

Have a sheriff car in getting lettered. The car is black, doors have been wrapped white, not by us I assumed from the factory. After removing registration marks (layered vinyl job) off the wrapped doors, it appears that the door wrap had a liquid laminate on it. The reg. marks pulled some of...

How well does a vinyl wrap hold up on the side of a boat where half of it would be submerged under water most of the time and the edges of the wrap will constantly crash through the water? Will a high tack vinyl hold up much better?

Has anybody applied vinyl graphics to cor ten steel. Cor ten steel is designed to form a layer of rust which acts as a protective coating for the steel. Just wondering if this affects vinyl lettering at all? Will the rust bleed down over the lettering or cause it to fall off?

Customer wants an 80'x10' banner to install on the side of a 100'x18' building wall which faces a freeway. It's an advertisement for a new industrial park and they will install the banner themselves, the wall is corrugated steel siding. They want a banner and not aluminum panels because they...

Anybody know this one?

Anybody know this font?

I'm trying to figure out what the best material would be to use for pre-spaced removable wall graphics. Specifically I need to print and cut text (4'x2') to go up on a wall for 2 months. Wall is painted sheet rock with eggshell finish, so has a bit of a texture to it. I'm looking into oracal...

Anybody know the font for the phone number?

What is the best way to remove old (10+ yrs) lettering enamel from a truck door without damaging the truck's paint? It isn't much, just an underline about 15"x.5".