Search results

I have the drytac spoton. But I don't like the little spot design when you look close and it's too easy to remove like the glass adhere.

So I need suggestions for a material. Right now, I'm using GlassAdhere frost for printing that we can see both side. It's a great product, but I need something with real adhesive like regular frosted vinyl because it is too easy for people to remove the material. So I need a printable frosted...

if it's bfree mactac, I use regular medium-tack paper premask without any problem. I prefer to premask the hole thing because it as tendency to stretch without it.

I use 3M SCPS-53X transfer tape. If there is only a small part that is cut out, I premask just that part. Wet apply, squeegee down, wet the hell of the transfer tape, wait 5 to 10 minutes and the transfer tape practically fall off itself. Even for small parts like 1/4 X 1/4 it work well. If you...

Hi I'm looking for a frosted colors film supplier. Ideally in Canada. I'm looking for orange frosted film. Thanks.

Welcome! I'm located less than 30min from you. I could be able to help you if you want.

I'm in the montreal area, thanks.

Great, thank you for the information.

I would prefer a commercial grade product with a manufacturer/distributor that will give me support. I've installed frosted vinyl and tint film once that have been purchased at home depot and it suck.

Hi, I'm looking for a one-way mirror film distributor in Canada. Or at least a manufacturer I could ask for a dealer reference. Thanks.

I just had a flash and went ton the drytac website to check the profile list. So my printer is listed for this material, but the profile is for Onyx and I have Caldera. If it was not a backlit film, I would create my own profile. So knowing that, what should I do and/or test? Thank you.

So I have an HP 260 and just tried the Drytac reveal 7mil backlit film. From the spec, it's compatible with latex and UV ink. With my other film, I use the generic backlit film. With the Drytac, I had adjust the heat from 90 celcius to 110 celcius and the ink is still wet on heavy coverage. The...

Does anyone know if it will be an hybrid printer?

Damn! Up here we charge 6$/sqft with installation for 3M product. This is without print or cut.

I pulled out this printer off my wish list at first. But after the comment here, I'll stop my purchase progress to know more about it.

I'm not a MM and I'm not in the US, but anyone with a EDGE printer would be able to do this.

Perfect, thank you. Now I just need the avery one.

No one else?

Yep, work perfectly for the 3mm. I use it few times per week and it still work flawless.

Thank you. I've found both of them. The avery, we had to pay for it and it's not a file made by avery directly. The 3M one is not compatible with the latest version of illustrator.