Search results

My capping head was bad, had it change, also change my pump, had it soaked over night but not much has changed should i have it soak longer ?

Had an error 1c3 SLDR2H had a bad slider board, replaced it with a new one fixed the issue

Yes thanks, I brought up the heat 45-45-50 and worked perfectly for highspeed

Having and issue since i switched jetbest refill cat ridges, on a highspeed print results aren't the best only on normal speed, with any ideas. Like it's laying down way more ink than the usual regular cartridges (need some help) tried manual cleans ... head fires properly

I'm having the same issue printing on high speed since i switch so jetbest with the refill bottles on top i realized it's laying down more ink than running regular cartridges, not sure if I'm wrong did you get it working better, any ideas anyone

yes everything is intact, error occurred after a powered fluctuation.

Has anyone got this error or know what it means

Anyone got this error before

THANKS WILL CHECK IT OUT.

I did a ultra clean took sometime to see some ink drop out but wasn't much.

It's a new machine only running it about five months now ink cartridges had ink they abit low but still has about 30% but i realize both it' using from both the cyans, i'm running dual CMYK

Running dual CYMK

one cyan section has gone completely, done several cleans, custody wash and a ink fill up nothing so far. What else can I do or what could cause the problem

I have a Hp l25500 just bought a set of brand new heads and the lc/mg head keeps asking to be re-seat, clean the contacts with alcohol but that didn't work, updated the firmware to the recent one still didn't fix the problem, anyone have idea what should i do, do I return the head for a...

Did you ever got the problem fix i'm having the same issue new head, had mother board repaired but no print ink valves doesn't open ? gives error 07

I did the exact same thing you told me but i realized the cartridges values wouldn't open automatically, the other thing is checked my ink and didn't realize all the inks are expired, so i'm stuck do i buy new cartridges and try again cause i tried a ink fill up and no values, but if i do it...

Installed a new head recently due to dead head, sent a job, printing for a couple seconds there was no ink coming out but i also realized my dampers were bad due to the printer staying down for a while. My question is: Is the head damaged already or should i just get new dampers and fill them...

I'm getting this errror changed head memory, changed head cables, what would be the best option pcb slider board or a main board?