Search results

Got it! Thank you!

Hello. I am looking to buy some equipment for my shop. Can anyone recommend a transport company or transport broker for shipping? Thank you!

Hello everyone. Does anyone know where to change from mm to in. in the settings? Thank you

Before I weld it . I just wanted to know if there is a part that can be replaced or repaired. I tried calling seal but I could not get a live person on the phone, still waiting on call back. Thank you for your feedback, it is much appreciated.

I thought about welding it also. lol, but it would be pain in my rear if I ever had to take it apart for something else. Please post the pictures. thank you.

Here is a picture https://flic.kr/p/PYZkDG

Hello everyone. I have a seal model el 54. The gear that moves the chain and makes the rollers move is slipping from the shaft. I was able to tighten up the two set screws before and it would work fine for a while, but now I tighten the set screws as tight as possible and the gear is still...

@aerosigns

It's just like buying a car. Look for for one with low miles and a good owner.

Got It. I run the printer using Flexie, So I don't use the raster link. I just wasn't sure. Thanks Again.

This key was included when I bought my printer. When I plug it in to my cpu nothing happens. I am not sure what it for.

They look great. What Brand of printer did you use?

Thanks. I will give it try.

Sounds Like a Fun.

I am printing on Arlon 6000 using a jv3. I am not sure what to set the print heat at. Is there a general rule of setting temps? Thanks

Thanks for all the insight guys. How do I access the service menu to do the alignments?

No over spray. Just banding. notice the magenta and cyan don't touch. Can this be adjusted?

Took the print head off and flushed it with solvent. Looks a little better. But not good enough . Any body now the best place to buy a new print head?

I changed the dampers. No change at all. any other suggestions?