Search results

Thanks for the answers! I wasn't trying to skimp on anything, that's why I asked! So the seam would be undesirable!

I searched this site and the Internet , a lot of talk of etching primer! I tested the Zinsser primer on a smaller piece of aluminum and then painted with latex, seems fine, but was concerned about long term?

I got the aluminum for free, 1/8"x4'x8', bare unfinished , was just trying to take advantage of it being free and use it!

What if I have to put a seam in the 751 used to cover the aluminum, what is the recommended over lap? Would it be best to avoid lettering over the seem? I really appriciate all you help, thanks!

Thanks for the answers on the vinyl ? , how about the primer ?

Also has anyone used Zinsser primer from lowes on bare aluminum ? It says it can be used on aluminum? It is a water clean up primer!

Is it ok to cover bare unfinished aluminum with 751 vinyl then letter on top with 751? Instead of painting the aluminum? If so what is the best way to achieve this? Thanks!

Thank you for the replies!

I wouldn't try to print 4'x8' with this printer, the whole sign might be that big with smaller stuff dp on it, along with cut vinyl

Thanks everyone for the answers, helped a lot!

Thanks for the answers I recieved so far! I am on a budget but I am looking to be able to do some digital printing, as an add on to vinyl cutting. I mostly do smaller signs 4 by 8 being the largest and vehicle lettering, would like to combine the two ( dp and cut vinyl ) on the same job! My...

My thoughts are to trim off the extra lamination film and reload to contour cut? Is this my best solution to small outdoor signage ? I have been doing cut vinyl for years, but this digital printing is all new to me! I have learned a lot just reading on here, Thank you everyone !

I am new to digital printing and was researching printers and laminators, so I have a few questions . I just watched the big squeegee videos on you tube, so being that I have budget constraints am I right in thinking I don't need a laminator right off the bat? This can be done with the big...

Maybe Maybe I should just not get this printer!

Does anyone know if any supplier carries cast vinyl and cast laminate for the versastudio bn 20? Would I be ok using Roland's cal. Vinyl with cast laminate, can't seem to find that size anywhere ! Any help with this subject would be greatly appreciated ! I wanna do small outdoor signage ...

I am new here, just wanted to say hello and thanks for having me!