Search results

Maybe not the best option for this project since the current stripes are vinyl and can be removed, but we did a color change for painted stripes on a Chevelle recently. Put knifeless tape around the stripes, used a couple feet of 1080 and were done in no time. No bothering with measuring or...

We printed a couple rolls of thick floor graphics recently and we printed them in about 6' long sets and loaded full rolls on our S2 T160. When cutting we ran them very slow and have the vinyl run out over a table and not into the basket or on the take up roll. Between sets we paused and cut...

I have used Arlon 8000 with good success in the past for printed square cut porta potty graphics, haven't tried out the 8200 yet

FireSprint

Xirod

Try Introblues Script

Good eye! Thank you!

This font is so familiar but I can't seem to find a match, any help is appreciated!

I get a lot of request for "ghost" graphics on emergency vehicles that aren't white or black vehicles. Blues, greens, tans, etc.. We typically just throw a pantone book on the vehicle, if it's available, and get a close match and print it on 3M IJ680, is that standard? Is there a translucent...

Look up Ricoh Invisible Red Toner. It prints clear but under a black light it glows red.

We built this a couple months ago.. took about 2-2.5 hours and $175 at Home Depot. Full sheets go on the bottom and cut sheets/misc up top. Rolls around the warehouse well, might put a hitch on it so the fork lift can pull it around

No luck so far with a match, Good Times was close, but requires quite a bit of tweaking. Any ideas? Thanks!

With a little help from a heat gun we've had good success removing it. Just go back with some alcohol to get whatever adhesive is left after the vinyl is gone. I even recently pulled off a section of 680cr about 2'x2' all in one piece that had been on our shop floor for over a year.

We use 3M680CR for all emergency vehicle printed graphics and striping. May cost a little more up front, but it makes installs and removals a lot easier.

Maybe try ARK Ramos

Thank you!

Any ideas? I found a couple that are close, but not quite there. Breakers Slab/Quatro Slab Thanks!

Howdy! I am looking for a vehicle graphic installer(s) or install group for long term(sporadic) work in Belton, Texas. We currently print and install everything ourselves, but we're looking at subbing out the install portion. Materials installed will be 3MIJ680CR/3M680CR/3M1080. Most...

We use Pro Vehicle Outlines, but I don't see Tesla listed and maybe I'm blind, but the BMW category is blank after 2010...

How much is a sign?