Search results

Looking for an original version of Mimaki Fine Cuts 8.

SOLD

SOLD

I'm looking for a PC disk of Mimaki Finecut Software for Illustrator CS2. If you have one for sale please message me. Thanks

SOLD

SOLD

Here's something to add to the discussion, What do you think about having cameras in the production areas? Too "Big Brother"? It would cut down on fool'in around and possibly theft.

OK, I think I got this figured out. I have an exhaust fan in my print room. I shut it off and listened for the fans to kick on (After sending the print) and they never did. I changed profiles and they kicked right on. I determined that some of the profiles I was using was kicking off the...

Rolling out extra material is common practice for me. I started out only using the outer rollers only (Which were changed out by a Roland Tech and visually confirmed by the colored edges) until the wrinkles began then I loaded all of them in, which didn't work. I've tried 3M, Oracal and...

I took the back plate off and it was very clean, but I cleaned in and around the fans anyway. The holes on top were free of any debris. I loaded some vinyl, fed it out about 2 ft. and fed it back and the wrinkles we're still there. I did change the vacuum power from "Auto" to 100% and for...

I'm sorry if I didn't explain well enough. I usually print with NO heat at all and it prints fine, but in the event that the vinyl wrinkles when I load it in the machine my first fix is to try a little heat. I turn on the heat and adjust it by 6 degrees until the wrinkles go away (Which they...

nucleus, Thanks for the reply. I've often felt it was a vacuum problem but was a little leery opening that part of the machine up. I'll check it out. thank you for your time and the pics.

Alpha, I've replaced all pinch rollers in the last months and I've cleaned the grit rollers. It almost seems like the grit rollers are sitting a little high, not allowing the vinyl to lay flat. I'll try your suggestions tomorrow and report. Thank you

splizaat, I usually do not run heat at all and it runs just fine. I only turned on the heat testing in intervals of 6 degrees at a time once the problem began. Room Temp: 72f Humidity: 20% Thanks for the input.

Thank you Alpha, that's it exactly. I usually run with NO heat and it runs fine. I only added heat to get it to lay down. I'm getting wrinkles in between the rollers and I'm not sure why.

The Vertical Bands correspond with type of wrinkles in Photo 1. Heat set at 116 Print 116 Dry as I've tried every setting up to that point. Material: 3M IJ-35-10. Room Temp: 73 F Humidity: 25% :frustrated:

Hello All, Has anyone seen this before (see photos). I'm using a Roland SP-540v. I've adjusted the heat, did every kind of alignment, changed material, replaced the encoder strip, replaced the rollers, adjusted the vacuum, tried different profiles, Rolled out excess material ahead of...

Does anyone here consider themselves proficient in the setup of GraphiXCALC and would be willing to counsel via phone? I have a few questions that the manual doesn't quite answer and I've been unable to contact the company. thanks in advance.

Hello, I bought your software almost 2 years ago and I'm trying to figure out how to achieve a consistent price and I'm having no luck. I love how it's setup, I just need some questions answered that the manual doesn't cover. Thanks, David 317-308-1900 anytime

Can Anyone recommend I reliable Font Management Software? "Keeping it simple" has gone out the door, so my font library has grown out of control. I'm more interested in paying for the software rather than any "shareware" or "freeware". Thanks