Search results

Fred offers many individual images on the following site: http://www.expressclipart.com

One issue that I think ties into to the "knots and eddies" you mention is the family tree of Flexi and its acquisitions along the way. When Amiable and Scanvec merged, alot of changes were made and still being made in efforts to make as many as possible happy from the old CASmate DOS users...

It is possible for the original damper to drip one or two drops but all I have changed, the ink retracts back to the cartridge side. I use a pair of Needle nosed pliers to grab the flange on the left side of the damper and lift straight up. Once off, I place in ziplock back immediately, while...

www.printingdigital.net may have some tips too. Link also at the bottom of each page of this site.

Thanks for stepping up

Versaworks will not drive an independent cutter.

A dab of cleaning fluid on the o-ring within the new damper will make it easier and safer to install.

many little bugs resolved in the 8.1v1... 8.0v3 had a file corruption/loss bug that would randomly corrupt/delete files.

Update to 8.1v1 and then in the Color Settings, make sure Gradient settings within Rendering Intent are set to Perceptual or Relative Colorimetric. There is also a setting in the RIP to smooth gradients.

Parallel or serial connection?

Encoder strip and/or encoder sensor may need to be replaced... another thing that can cause this is loose wire tension on the carriage wire.

Do you mean, DDR2 PC2-6400/DDRII-800 ?? 1GB CT12864AA80E DDR2 PC2-6400 • CL=5 • UNBUFFERED • NON-ECC • DDR2-800 • 1.8V • 128Meg x 64 $75.00

Insert cleaning cartridge into fubar'd ink cartridge and do as Compilla stated.

unplug the desktop printer and reboot... then try again. Thinking about the sheet set error

Welcome, from Norcross !

What is the purpose of the 'bump' post? Once the cutter gets some age on it, cut objects may not close and circles may not be concentric... I resolved this issue by adjusting the gain on the mainboard as well as slightly bending a plate on the top of the cuthead assembly... Easy to remove...

Do you know the IP of the router? If so, type that IP into the DNS. Are you accessing the internet from the computer in question?

Depends on your ISP. Ideally, your router should assign your computer's IP and DNS (DHCP). The only setting that may need to me manually assigned is the Default Gateway, which should be the router's IP address.

Have the client re-export the file as Legacy Illustrator EPS

Is this only in a portion of the gradient or all of it? Flexi has an option in the RIP/Print for Smooth Gradients... Might try that. Also check the EDIT>COLOR SETTINGS... Gradients should be set to Relative Colorimetric