Search results

I suggested that 7 minutes after you posted the problem! And this morning too...

Windows can use a different protocol to communicate with devices on the network. It does not rely solely on TCPIP (AppleTalk, for example... or NetBIOS/NetBUI, WINS, etc..) It is an indication that the physical connection may be OK.. which means that the problem is in the TCPIP configuration...

Trace Route!? There is only one thing between the PC & the printer...(the router). What do you expect that a tracert will tell you? They are on the same switch! My computer & printer are both plugged into the same little D-Link switch (which is uplinked to a router). The d-link is a dumb...

I have a roll, call me if you need some/.

We use 651 White now & then, especially for small run coros. It is calendared and will crack & shrink outside, especially here in AZ!

Joe... You were trying to be serious and offer the guy legitimate advice... I was just banging on him. I'll take the bullet for this one. You got hit in the crossfire.

I just got a call from a custy that wanted me to print white onto black matte card stock. I sent him to a screen printer.

RandyA was in Washington (State) two days ago... may still be there. He has been away from the PC.

do you get link lights on the router/switch? No>? Bad Cable, Bad Switch Port, Bad Ethernet Card in Printer, Loose/Broken RJ45 connector, Used crossover cable instead of straight, Jack wired incorrectly, etc... Yes>? IP in Printer different (192.168.0.x versus 192.168.1.x), Bad subnet...

I have an HP 5SI and 5P (both B/W Lasers).... The 5SI is a tank, prints duplex on 11x17. There is always one or two on Craigslist. It is easily 15yrs old. I do (now & then) want to do a color proof, but usually just email a low res jpg instead.

invest it wisely

My father used to say it was better to be a smartass than a dumbass.... looks like he was right!

LOL! Foster's getting good use out of his Corel skills!

Dood... If you can't draw a stick figure it is time to hang up the cricut and retire.

dood... this thread is 3 years old.

Well, It was ALOT of cleaning!! Yep.. I hardly ever touch the maintenance station. I usually just wipe down the bottom of the print head, but even then only when I see a printing problem. I am going to be a good boy from now on and (now that I know that maintenance station intimately) will...

Well, before dropping a few hundos on a maintenance station I thought I would take a crack at fixing the old one. In one of my past lives I was a printer/pc/lan tech weenie so I have a bunch of experience fixing printers.... just not these giant inkjets. Turns out the maintenance station...

Sell it and go find a job you are qualified to do. Obama says you don't have to work for almost 2 years (if you can afford to live on unemployment) Hey... go to a chef/restaurant forum and make a post like this: I got laid off recently, but when my wife's dad died last year I inherited a...

If you used 1/16 Rowmark you cleared about $275 over your material costs. How much time did they take you to run? We use Excel to estimate engraving jobs, but scaling for large pieces gets tricky... It is hard to be precise estimating run time on the engraver and also adjusting the price...

You bought a crappy $300 inkjet printer with clog prone printheads... then added a bulk ink system so you can print paper transfers that you heat press onto shirts? And you are disappointed that it does not print as well as a $20k DTG? Dude.... you got exactly what you paid for, but if...